Vertex Standard VX-454 User Manual download pdf (Page 10)

VX-450 SERIES OPERATING MANUAL

BEFORE YOU BEGIN

Battery Pack Installation and Removal

 To install the battery pack, align the battery pack

to the radio with an offset about 1/2 inch from the

top edge of battery compartment, then slide the

battery pack upward until it locks in place with a

“Click.”

Low Battery Indication

As the battery discharges during use, the voltage

gradually becomes lower. When the battery voltage

becomes to low, substitute a freshly charged battery

and recharge the depleted pack. The LED indicator

on the top of the radio will blink red when the bat-

tery voltage is low.

Caution

Danger of explosion if battery is replaced with

an incorrect battery. Replace only with the same

or equivalent type.

Battery Charging

 Referring to Figure 1, adjust

the direction of the Battery

Holder of the CD-49 Desktop

Charger in accordance with

the battery pack being

charged; Push in both sides of

the Battery Holder while pull-

ing up on the Battery Holder

to remove it from the charger

base, select the correct direc-

tion of the Battery Holder for

the battery being charged, then

 To remove the battery, turn the radio off and re-

move any protective cases. Slide the Battery Pack

Latch on the bottom of the radio toward the front

panel while sliding the battery down about 1/2

inch. Then lift the battery out from the radio.

Do not attempt to open any of the recharge-

able Lithium-Ion packs, as they could ex-

plode if accidentally short-circuited.

Wide

FIGURE 1

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

No comments

Vertex Standard VX-454 User Manual Page 10