Vertex Standard VX-456 Specifications download pdf (Page 12)

VX-456 Operating Manual

Before You BegIn

Battery Pack Installation and Removal

To install the battery pack, align the battery pack

to the radio with an offset about 1/2 inch from

the top edge of battery compartment, then slide

the battery pack upward until it locks in place

with a “Click.”

To remove the battery, turn the radio off and

remove any protective cases. Slide the Battery

Pack Latch on the bottom of the radio toward

the front panel while sliding the battery down

about 1/2 inch. Then lift the battery out from the

radio.

Do not attempt to open any of the re-

chargeable Lithium-Ion packs, as they

could explode if accidentally short-circuited.

Low Battery Indication

As the battery discharges during use, the voltage

gradually becomes lower. When the battery voltage

becomes to low, substitute a freshly charged battery

and recharge the depleted pack. The LED indicator

on the top of the radio will blink red when the bat-

tery voltage is low.

CAUTION

Danger of explosion if battery is replaced

with an incorrect battery. Replace only with

the same or equivalent type.

Battery Charging

r

Remove the Spacer Plate from the nest of the

optional

CD-58

Desktop Charger, if the Battery

Spacer is installed.

Insert the DC plug from the optional

PA-55H

AC Adapter into the DC jack on the rear panel

of the optional

CD-58

Desktop Charger, and

then connect the

PA-55H

AC Adapter to the AC

line outlet.

Insert the battery pack into the

CD-58

Desktop

Charger while aligning the slots of the battery

pack with the guides in the nest of the

CD-58

;

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

Comments to this Manuals

No comments

Vertex Standard VX-456 Specifications Page 12

Comments to this Manuals