Vertex Standard VX-454 User Manual download pdf (Page 11)

VX-450 SERIES OPERATING MANUAL

BEFORE YOU BEGIN

replace the Battery Holder by pressing down on

both sides of the Battery Holder, if necessary.

 Referring to Figure 2, insert the DC plug from

the optional PA-45 AC Adapter into the DC jack

on the rear panel of the CD-49 Desktop Charger,

and then plug the PA-45 AC Adapter into the

AC line outlet.

 Insert the battery pack into the CD-49 Desktop

Charger while aligning the slots of the battery

pack with the guides in the nest of the CD-49;

refer to the illustration at the right for details on

proper positioning of the battery pack. If charg-

ing with the transceiver attached, turn the trans-

ceiver off. The antenna jack should be at the left

side when viewing the charger from the front.

 If the battery pack is inserted correctly, the LED

indicator will glow red. A fully-discharged bat-

tery pack will charge completely in 1.5 - 3.0 hours

(depending on the battery pack being charged).

 When charging is completed, the LED indicator

will change to green.

 Disconnect the battery pack from the CD-49

Desktop Charger and unplug the PA-45 AC

Adapter from the AC line outlet.

1) Always use the Vertex Standard Co., Ltd.

Model FNB-V112LI or FNB-V113LI

Lithium-Ion Battery Pack.

2) Battery Pack shall not be exposed to excessive

heat such as sunshine, fire, or the like.

3) Risk of explosion if battery is replaced by an in-

correct type. Dispose of used batteries according to

the instructions

4) Perform the battery charging where the ambient

tempera-ture range +5 °C to +35 °C. Charge out of

this range could cause damage to the battery pack.

5) Use only the Vertex Standard Co., Ltd. Model

PA-45 AC Adapter.

FIGURE 2

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

No comments

Vertex Standard VX-454 User Manual Page 11